The emergence of bee-keeping vehicles has opened up a new way of bee-keeping to many apologists. However, after using the beekeeping vehicle for a period of time, it will be discovered that the theft of bees will occur. Grasping the following methods and techniques can effectively reduce the phenomenon of rogues. 1. Bees stayed in the bee-keeping vehicle for a long period of time. When the outside world lacks honey, the relocation of the bee population is most likely to occur. Therefore, when keeping bees or collecting honey out of the box, the time used should be reduced as much as possible, so that the bees do not have sufficient time to carry out group-type movements. At the same time, honey should be used to properly fill the cracks in the beehive, and under normal circumstances, it is better not to open the box without opening the box. 2. When collecting honey, be cautious and try not to spill the freshly harvested honey around the beehive. 3. At the time of feeding, be sure to wait until all bees have returned to the beehive, and it is advisable to feed when the day is about to darken. Moreover, in the preparation of the amount of feed, it must not be too much, it should be the amount that can be consumed on the same day as the best. 4. If the burglar phenomenon has already emerged, it is necessary to adopt the following methods to prevent it in a timely manner. First, minimize the beehive's nest door, then gently apply a thin layer of cool oil around the nest door, and at the same time, use some cool oil to fill in the gap around the beehive. In this way, the returned bees of the outside group can continue to fly into the beehive through the nest door, and the robbers do not dare to fly into the nest door to steal the bee or steal the honey because of the irritating smell of the cool oil. . The above is a method and technique that can well prevent and prevent the occurrence of the theft or robberism of small-scale beekeeping vehicles. It is worth reminding everyone that when the phenomenon of the theft of beekeeping has begun to appear, we must first maintain a calm state of mind. Don't be too frantic, and then start a timely stop. When cool oil is not found, other irritating substances that are not too irritating may also be used as related substitutes.
Raw material is hot-rolled round steel, which is forged by air hammer and heat-treated to become a high-quality Grinding Ball. The Forged Steel Ball has high volume hardness, compact structure, fine grain and good wear resistance. Due to the stable quality of the raw materials, the impact toughness is as high as 12-15 J/cm2, and the breaking rate is less than 1%. Especially the large-diameter Steel Ball has the advantage that the cast steel ball cannot be achieved in the SAG mill.
Grinding Ball,Grinding Media Steel Ball,Forged Grinding Ball,Forgeing Grinding Ball Jinan Zhongwei Casting And Forging Grinding Ball Co.,Ltd , https://www.cngrindingballs.com