CNC Plasma cutting machine is a automatic and high efficiency engraving equipment.
It is widely used in all kinds of carbon steel, Stainless and non-ferrous metal precision sheet metal cutting. Iron, aluminum,
galvanized steel, stainless steel, titanium plate.
The machine is used Heavy steel tube,
Annealing treatmaet( the structure is put in very high tempreture fire to make it more stronger), very firmly and durable
Adopt Gantry Structure, table Movement.
Wie higher precision and the structure is Morea reasonable
1.The machine is suitable for diversified and complex processing. It is widely used in 3d engraving, drilling, cutting, edging, hollowing, milling shape and so on
2. High processing speed and high efficiency.
3. High speed cnc woodworking atc center.
4. Woodworking industry: Dimensional wave board processing, cabinet doors, craft doors, paint free doors, screens, window processing mill products shaped sculpture machine
5. Also can be used in processing aluminum board, insulation board,kinds of engineering plastics, MDF,particleboard,Laminate,Solid wood panel, fairway board and others non-metal and soft metal materials.
Cnc Plasma Cutting Machine,Portable Cnc Plasma Cutting Machine,Cnc Plasma Cutting Table,Plasma Metal Cutting Machine Nanjing Diding Numerical Control Technology Co.,Ltd. , https://www.dinglicncmachine.com
Too bad a grid must be equipped with a regulated source.
In addition to the normal maintenance of cleanliness and lubrication, medium-cutting wire-cutting machine tools must also carefully maintain the following parts:
The guide rail and screw of the thread cutting machine tool must not be contaminated with dirty water and dirt. Once it is stained with dirt, it must be wiped clean with a clean cotton yarn and then lightly rubbed with a cotton wool soaked in 10# oil again.
Guide wheels and bearings, for the life of the guide pulleys and bearings, should also replace the excessively dirty coolant. If the machine is not turned on for a short time, it is necessary to let the guide wheel turn for tens of seconds without water, so that the guide wheel and the guide wheel cover The dirty water is thrown out, a small amount of oil is injected and then transferred for several tens of seconds, so that the oil and dirt in the gap are thrown out, and then a small amount of oil is injected. In order to make the guide wheel and bearing often in a relatively clean state.
Couplings and keys on the spool shaft and the motor must always be in a tight and secure state. Once the looseness of the key and the crash of the coupling occur, the cushion and the key of the coupling must be replaced immediately. After long time commutation with clearance, the keyway on the shaft will be deformed and expanded.
The cable between the control cabinet and the machine must be protected by a cover plate or plastic plate. Do not step on it. The cable should be in a relaxed and free state. Do not pull the cable outside, do not force the cable plug, and do not protect the cable. Set of fracturing treads.
The console (cabinet) must be handled with care, and do not insert or remove the touch connector or keyboard with oily hands. No part of the bed should be knocked or hit. In particular, the wire frame must not interfere with the bed surface due to the over-travel movement. This will seriously damage the machine parts or accuracy.
Attention should always be paid to keeping the conductive block in good electrical conduction and in isolation from the bed of the wire-cutting wire cutting machine. The workbench pad must be insulated from the bed, and the stepper motor must be in a free state. Stepping motor Make sure that no dirty water enters the dip.
Method for maintenance and maintenance of medium wire cutting machine
The medium-cutting wire-cutting machine tool is not suitable for working in dirty and high-temperature and humid environments. The power supply environment of the power grid also has high requirements. The power supply voltage of the machine tool should not be inferior to ±10%, and the balance and stability of the three are corresponding.