Guidance: Laser marking machine worktable XY axis is not accurate, it will cause great errors on the processed products. If the problem can not be resolved in time may affect the delivery time of the product, the following brief introduction of the laser marking machine table XY axis troubleshooting methods. The XY axis of the laser marking machine worktable is not accurate and will cause great errors in the processed products. If the problem can not be resolved in time may affect the delivery time of the product, the following brief introduction of the laser marking machine table XY axis troubleshooting methods. mono Screw Pump aslo beed called single screw pump. pump beed usde to transfer sludge, mud and sauce etc thick liquid. the general mono screw pump is be used to transfer sludge, mud etc thick liquid. it's have large flow rate and high pressure. stainless steel material mono screw pump can be used to transfer tomato sauce, bolognese, sesame sauce etc, pump also can with the hopper and reamer. all according customer's requirment. single screw pump belongs to the rotor type positive displacement pump, it is depend on the screw meshing with liner on the discharge and suction cavity to conveying liquid volume change.It is a kind of method of pressurized screw pump, a main working parts by bushing has a double helix cavity (stator) and the stator cavity and its meshing single-head screw screw (rotor).When the input shaft through the universal joint drive making planets revolving around the center of the stator, rotor stator, rotor, vice is continuous mesh form sealed cavity, the seal chamber volume invariably uniform axial movement, the medium from the suction end of deputy to the stator, rotor pressure side, the suction medium sealed cavity through the stator without stirring and destruction. Mono Screw Pump,Industrial Screw Pump,Sludge Screw Pump,Mono Single Screw Pump Botou Honghai Pump Co.,Ltd , https://www.pumphonghai.com
There are several reasons and troubleshooting methods for the table XY axis is not accurate.
1, the whole machine optical screw loose, need to tighten the screws.
2. The glass on the workbench is set with the requirements of the customer. It can be replaced with iron plate or plexiglass plate, and the balance of the glass can be adjusted below.
3. The electronic ruler can be installed on the right side and the upper and lower corners of the worktable. The electronic ruler can be installed to facilitate the needs of customers.
4. The screw hole on the workbench can be used for positioning by the customer and is negated by the product.
5, XY axis jitter walk, need to check the motor, driver, signal line, drive power is faulty, replace if there is
6, in addition to the above, the XY axis is still not allowed, it may be a motherboard failure.