Round Cotton Pad Making Machine
This machine adopts cutting and oil heating to produce cotton spunlace non woven facial pads automatically. We can do different cotton pad layers and patterns according to customer requirements. The machine can reach the speed of 360-500 pcs/min. We can make the machine according to the customer's detailed
requirement. Only need to change the mold of different products size.
Round Cotton Pad Making Machine Round Cotton Pad Making Machine,Round Cotton Pad Machine,Round Cotton Machine,Disposable Round Cotton Pad Machine KYD Automatic Mask Machine Factory , https://www.kydultrasonic.com
Ground insulation system construction preparation
1. Before the laying of the ground insulation system, the construction of the ground wall must be completed and the foundation leveled. There is no other work in the site.
2. The temperature in the construction room should meet the requirements for proper use of the pipe, because the ambient temperature is closely related to the bending radius of the pipe.
3. Clean the floor and walls, and use a level gauge to verify the flatness of the ground. The height difference within 1 meter is less than or equal to 5 millimeters. The wall or ground protruding part is removed with a shovel, and the ground pit is filled with concrete.
4, the bathroom and the villa should be done at the bottom of the waterproof layer or laying moisture-proof membrane.
Floor heating special boundary insulation construction
1. Before laying the boundary insulation strip, clean the wall, ensure the flatness of the wall surface, and avoid the insulation strip falling off in the process of construction and use.
2. The boundary insulation strip shall be affixed on the wall surface and the cylinder surface at the intersection of the ground in the heating area. The boundary insulation strip shall have excellent fastness to ensure that it will not fall off during use.
3, the border insulation strip should have a thickness of 8 mm, the boundary insulation strip must have a certain degree of flexibility, to ensure that the backfill layer plays a role in buffering after thermal expansion, the maximum compression is 5 mm. The extruded extruded board does not allow to replace the boundary insulation strip.
4. The lap joint should be used at the junction of the boundary heat insulation strip, and the length of the lap joint should not be less than 3 cm.
After reading the above information, you must pay attention to each step when installing the floor heating, especially in the installation process, the need to pay attention to matters must be careful.
Did you pay attention to floor heating?
Nowadays, more and more people choose to warm up in winter heating. It can be seen that the floor heating has been deeply rooted in people's hearts. Everyone has a certain understanding of floor heating products. They think that as long as they have bought a good product, they can enjoy a comfortable winter in the future. People often fall into this misunderstanding, and it is far from enough to place floor heating only on the quality of the product. Floor heating is also a top priority. In particular, the construction quality of the floor heating insulation system is often overlooked. Today, the Shanghai floor heating experts took everyone to discuss some of the considerations in the construction of the floor heating insulation system.